Frame Relay was developed to solve communication problems that other protocols could not: the increased need for higher speeds, an increased need for large bandwidth efficiency, particularly for clumping ("bursty" traffic), an increase in intelligent network devices that lower protocol processing, and the need to connect LANs and WANs. Like X.25, Frame Relay is a packet-switched protocol. But the Frame-Relay process is streamlined. There are significant differences that make Frame Relay a faster, more efficient form of networking. A Frame-Relay network doesn't perform error detection, which results in a considerably smaller amount of overhead and faster processing than X.25. Frame Relay is also protocol independent-it accepts data from many different protocols. This data is encapsulated by the Frame-Relay equipment, not the network.

'Today's LANs and computing equipment have the potential to run at much higher speeds and transfer very large quantities of data. With the diversity and complexity of today's networks, management can be a mammoth task if you don't have the proper tools. Each environment is a unique combination of equipment from different vendors. Frame Relay uses a packet-switching technology, similar to X.25, but is more efficient. As a result, it can make your networking quicker, simpler, and less costly.

Frame Relay sends information in packets called frames through a shared Frame-Relay network. Each frame contains all the information necessary to route it to the correct destination. So in effect, each endpoint can communicate with many destinations over one access link to the network. And instead of being allocated a fixed amount of bandwidth, Frame-Relay services offer a CIR (committed information rate) at which data is transmitted. But if traffic and your service agreement allow, data can burst above your committed rate. Since Frame Relay has a low overhead, it's a perfect fit for today's complex networks. You get several clear benefits: First, multiple logical connections can be sent over a single physical connection, reducing your internetworking costs. By reducing the amount of processing required, you get improved performance and response time. And because Frame Relay uses a simple link layer protocol, your equipment usually requires only software changes or simple hardware modifications, so you don't

Is it time to look for t1 service? Many people are confused when they consider whether to upgrade from DSL or not. There are several factors to consider when examining you current DSL connection and the possiblity of replacing it. For many people the biggest factor is reliability and if reliability is critical to the applications you run over your connection you should seriously consider replacing your DSL connection with a T1. DSL is a quick and cost effective method of acquiring high speed bandwidth however it is not intended to support commercial applications or large numbers of users as are T1 connections.

Reliability becomes critical when customers or employees depend on your connection for immediate responses. If your customers use your connection to access your databases or your server or the internet then reliability of your connection is critical. If your employees depend on your connections because you host the e-mail server in house or host web servers or ASP type products, your connections is considered critical. A critical connection can be viewed much like a lifeline, without which your business would be negatively impacted. Your monthly savings of having a sub-par connections will not make up for the loss in productivity of your employees or loss of customers when your DSL connections gets bogged down or cut off. To reiterate, ciritcal connections should be supported with a T1.

Many customers are extremely price sensitive and cannot afford the cost of a T1 which can be as much as 20 times more expensive than a full T1 connection. Residential customers who are most sensitive to price should not consider a T1 circuit unless then have a business reason to pay for such a circuit and cannot access DSL service. Most people don't realize that a DSL connection can be just as fast as a T1 at 1.5Mbps. The shortcoming of DSL is that it is oversubscribed. This means there is a finite amount of bandwidth available and a customers speed can drop if other customers in the neighborhood decide to use their service. SDSL (Synchronous DSL) is a business class DSL and is ranked as a higher priority than residential DSL or ADSL (Asunchronous DSL). This means it is not oversubscribed to the extent than ADSL and is subject to fewer bandwidth restrictions. In short, if price is your critical factor go with DSL. If reliability is the critical factor purchase a dedicated T1.